Surely all of us - vehicle owners know how important the seat belt is . Although some people tend to ignore it, this part will be really useful when it comes to protecting you from injury in collisions.

Whether you can use it or not, always double-check each time you get in the car and make sure it can still work properly.

But unfortunately, it got stuck.何をするか？ How to fix a locked seatbelt ? Well reveal it to you!

How Does Seatbelt Work?

the power window doesnt work on t he driver side since debris clog all the rails.

誤ったインストール

When you install it incorrectly, it will have a self-locking mechanism. Because when it shrinks too much, it will get stuck, so people also call this reverse lock.

Bad Retractor

Your belts can be jamming due to poor or malfunctioning retractor mechanisms. You have three options in such a case: buy a brand-new seat belt, get a used one, or turn your present one back to factory standards.

Now, its time to learn how to fix a stuck seatbelt !

How To Fix A Locked Seatbelt?

まず、シートベルトがバックルされておらず、自由に移動できるかどうかを確認します。より多くのベルトを保持したら、少し引っ張ります。リトラクタを固定するのではなく、リトラクタに戻します。

ベルトのサイズとそれが垂れ下がる方法に注意してください。問題がすぐに元の場所に戻ってきた場合、問題は解決されます。

完全に格納できず、ゆるくぶら下がっていることがわかったときに、より深刻な問題を抱えることがあります。

2.絡み合ったシートベルト

そもそも、椅子を下げて、邪魔にならないようにします。次に、Trunks Floorの下のシートベルトシステムを検索します。

パーツ全体を取り出します

あなたがそれにアクセスした後、問題のあるシートベルトを引き出します。 To stop the belt from retracting, secure it at the top with a clamp or a sizable hair clip.

これで、その全長を慎重に検査できるようになりました。

To locate any knotted places, run it through your fingers. If you detect any little things on the fabric, remove them.

Clean it

As mentioned above, getting stuck in the dirt also causes the seatbelts to get stuck. Besides cleaning the car, this part also needs attention.

It is possible that dirt is not the main cause of this entrapment. However, when you have removed this part, take advantage of it to clean it to avoid causing a blockage in the future.

Put the belt in a pail of warm water with some laundry detergent dissolved and let it soak for a while, from 15 minutes to 30 minutes.

The belt should then be transferred from the bucket to the towel, which has been placed on the seat.

If possible, you can apply more internal cleaning methods or use the dedicated detergents for it. You need to pat dry the belt with the towel and then let it air dry completely.

もう一度チェック

Thats all for how to release a seatbelt that is locked due to the tangled ones. Check it again and again until it works properly and smoothly.

3. Stuck Mechanism

Clear The Side Panel

To fix the seat belt mechanism stuck , you need to make room to access its mechanism because it is located beneath the side panel.

There should be two side clips keeping it down in most automobiles.

These can be found along the cars bottom border. One is to the right of the B (center) pillar, and the other is to the left.

These clips can be raised by pushing a flat-headed screwdriver or pair of pliers underneath and then lifting them.

Find the little, locked compartment with the button that opens the trunk on the floor of your automobile, close to the center pillar.

Pull The Sid Panel Out

Sit in the cars back seat. Use a flat screwdriver to separate the side panel (the interior B-pillar of your car) if it appears to be tightly fastened to the vehicle.

Alternatively, you can use your hands to pull it away. Since no screws are holding the side panel to the car at this time, you shouldnt be experiencing any problems.

Bring Out The Mechanism

Bolts are used to fasten the retractor mechanism firmly. To unscrew them, you need keys of the right size. These typically come in 10mm and 14mm sizes.

Make sure to remove the clasp that holds the mechanism together as well. You can do this using your fingertips.

Now you can see a plastic cover; flip the item over. It is firmly fastened down with some tiny pins. You need to remove them, and any technique will do.

On the other side of the mechanism, there should be a small box with tiny clips. Use a flat object to loosen them.

Open And Remove The Plastic Pieces

There are two additional, smaller plastic components underneath the large cover. It would be better to take them out because they are lying on the equipment.

There should also be a spring on top of the second component. Eliminate that as well.

Deal With The Gear Wheel

Then use your fingers to turn the gear wheel in a clockwise direction. This action will clear the jam.

By tugging the belt, see whether you can easily rotate the gear. If everything is in working order, its time you need to reassemble the mechanism.

Reassemble And Test The Mechanism

The spring and smaller plastic components should be reattached. Then put the large plastic lid on top of them. Put the pins back inside the little box after securing it with the clips.

Back on the pillar, secure the bolts above and below the seat belt mechanism. Reattach the tiny device with a clip. After that, replace each panel where you originally removed it.

FAQ

Is It Possible To Replace The Seat Belt Buckle?

はい。 The parts that make up the seatbelt are usually separate and interchangeable.

You should purchase a replacement buckle from the dealer or manufacturer. Before using that seatbelt again, ensure the new buckle is installed correctly and functions as it should.

How Long Will It Take To Replace A Seatbelt?

Replacing a complete seatbelt should require no more than 30 to 60 minutes.

The mechanics ability and speed determine whether this time is faster or slower.

How Much Does It Cost To Repair A Seatbelt?

This will call for about $200 plus labor cost if the pre-tensioner is damaged.

It can require up to $250 to replace a seatbelt. Depending on the damage, repairing a seatbelt might get more expensive.

Its advisable to contact the mechanics or service center directly to know the exact price for your situation.

最終的な考え

Above is all the necessary information you should get to learn how to fix a locked seatbelt . Obviously, this task isnt as hard as we thought; it can be solved in 30 to 60 minutes.

To fix it, follow suit with our instructions step by step.

If your seatbelt issue is more severe, you might need to replace it or seek the assistance of a qualified mechanic.