1965 Ford Mustang Coupe

For sale is my 1965 Mustang coupe. Car runs and drives great. I've had it out on the highway multiple times. The overdrive transmission is really worth it. I have just lost interest in this classic and want to get into something newer.
This car is 90% finished and just needs the final touches to be perfect. I have every single part, screw, other hardware that is needed to complete the car. I'm sure many things will have double of and the buyer can go ahead and make some money off of selling all the excess parts once complete.
The car is completely rust free. All the body work was done prior to my owning the car.
Now onto the specifics:
Engine:
-Ford 5.0L roller block (bored .040)
- Block was bored, honed, crank was ground, brand new bearings installed
- Brand new pistons/rings
-Car is running Ford EFI with Ron Francis wiring and a ford A9L computer
-Ford GT40 heads (ported and 3 angle valve job)
-Comp Cams XE270HR custom cam
-Ford GT40 upper and lower intake
-BBK 70mm MAF sensor and Throttle Body
- MAF is calibrated for 24lb injectors and car comes with 24lb injectors
-Aluminum Radiator
-Canton Oil pan
-Heddman Elite headers (with 02 sensor bungs welded on)
-Custom EFI fuel tank with built in fuel pump
- Return lines running back to fuel pump as well (pump runs nice and quiet)
-BBK underdrive pullies
Transmission/Drivetrain:
-Running a ford t-5 transmission with a mustangsteve cable clutch conversion (ball bearing)
-Rear end is a Ford 9" big bearing rear end with 3.70 gears
-Custom made driveshaft for this application
-Hurst shifter
Brakes/Suspension:
-Car is running 4 wheel disc brakes adapted from 2005-09 Mustang GT's
-Power brake booster from a 2000 Mustang V6
-Front end had the shelby drop performed to lower the car
-all suspension is grab-a-trak springs with KYB Gas adjust shocks
-front and rear sway bars installed
-Running 17" Ford Bullitt wheels with 1" adapters on all 4 corners (car sits beautifully)
Interior:
-1989 Mustang Seats with adjustable side bolster and lumbar (Black seat covers installed)
-Nice wood grain steering wheel
-Car is wired with a complete body painless wiring kit (20120)
-carpet is in really good shape
-all glass in good shape
-door panels look good
-Front 3 point seat belts are installed and work great
-Rear 3 point seat belts come with the car and can be installed by new owner
Exterior:
-Like I said this car has 0 rust on it. All the underside is coated with truck bedliner for durability
-body panels are straight
I'll say again that I have boxes upon boxes of parts that will go with this car. In most cases you'll have plenty of extra stock once you're finished to either sell or hold onto until needed.
$500.00 deposit through Pay Pal is required within 24 hours. Remaining balance is due within the next seven (7) days either in Cash or Cashiers Check from a national bank in the exact amount owed. If using a cashiers check the car will not be released until the check has been confirmed and cleared by the bank which could take up to two weeks. The car is being sold "as is" with no warranty, either written or implied. Please ask any questions before bidding. All local laws for sale of car will be followed, no exceptions. Buyer will be solely responsible for picking up the vehicle.
NOTE: Only bidders, with a 95% rating (or better) AND a member of EBay longer than 6 months, will be considered. Please contact me first if you don't meet those requirements.

Also published at eBay.com