Seat leon cupra
Sale price: £2,500.00
make an offer
Technical specifications
| Manufacturer: | Seat |
| Model: | Leon |
| Year: | 2003 |
| Type: | Standard Car |
| Fuel Type: | Petrol |
| Mileage: | 63,000 |
| Transmission: | Manual |
| Door: | 4 |
| Got questions? | Ask the Seller |
Current customer rating:
()
based on 3 votes
()based on 3 votes
Photos
Description
Hi for sale is my Seat Leon Cupra
Work carried out in the last year
Timing Belt, water pump and Aux Belt was done in may
Had a full service at the end of December
Brembo discs and pads all round less that 3 months old
FK street coilovers and BBS CH reps 8j front 9j rear tyres are only 6 months old loads left on them
Forge yellow spring Actuator (not fitted)
Forge Splitter Valve
Neuspeed P-Flow induction kit
Porsche 911 oil cap
cupra r black head lining and trim to match including door seals
Door seal have been properly fixed with new seals in the carrier plates so no wet carpets
Stage 1 remap running 197 bhp with print out pulls strong and smooth
will run about 220 230 with a better exhaust and high flow manifold and a front mount intercooler
interior is clean no wear on seats
Bad bits
Its over ten years old so its going to have them
Drivers side front wing rusty easy fix
Bonnet as a stone chip that has some rust on it
Rear bumper was knocked so has a stress mark and the paint has cracked
M.OT runs out on 17th of March I will book in for a new MOT at the start of march
Advisory items on last MOT
Front and rear disks worn (Now changed for brembos all round)
Rear axle rusty (was cleaned and wax oiled)
Front rear bush's worn (was going to polly push the whole car but didn't get round to it)
All the serious things have been done so you have no worries there all i would recommend is polly bush the front or the whole car this was the last thing i planned to do but have gown bored and fancy a change.
I have been honest as possible car has nothing to hide any inspection welcome. Cash on Collection. No Test Drivers Call or Text on 07740983540
Also published at eBay.co.uk
Work carried out in the last year
Timing Belt, water pump and Aux Belt was done in may
Had a full service at the end of December
Brembo discs and pads all round less that 3 months old
FK street coilovers and BBS CH reps 8j front 9j rear tyres are only 6 months old loads left on them
Forge yellow spring Actuator (not fitted)
Forge Splitter Valve
Neuspeed P-Flow induction kit
Porsche 911 oil cap
cupra r black head lining and trim to match including door seals
Door seal have been properly fixed with new seals in the carrier plates so no wet carpets
Stage 1 remap running 197 bhp with print out pulls strong and smooth
will run about 220 230 with a better exhaust and high flow manifold and a front mount intercooler
interior is clean no wear on seats
Bad bits
Its over ten years old so its going to have them
Drivers side front wing rusty easy fix
Bonnet as a stone chip that has some rust on it
Rear bumper was knocked so has a stress mark and the paint has cracked
M.OT runs out on 17th of March I will book in for a new MOT at the start of march
Advisory items on last MOT
Front and rear disks worn (Now changed for brembos all round)
Rear axle rusty (was cleaned and wax oiled)
Front rear bush's worn (was going to polly push the whole car but didn't get round to it)
All the serious things have been done so you have no worries there all i would recommend is polly bush the front or the whole car this was the last thing i planned to do but have gown bored and fancy a change.
I have been honest as possible car has nothing to hide any inspection welcome. Cash on Collection. No Test Drivers Call or Text on 07740983540
Also published at eBay.co.uk
